Aluminum Titanate ( TiO2・Al2O3 ) CIP Products

Features

Aluminum Titanate ( TiO2・Al2O3 ) CIP Products(FTA-PS)

FTA-PS

CIP (Rubber Press) Products are highly and homogeneously condensed non-porous products because they are made under the ultra-high pressure in all the directions.
Rubber molds, which are suitable for smaller quantity production but less expensive, are used in the CIP manufacturing process.


Aluminum Titanate CIP Products are

  • Excellent in thermal shock resistance, because their coefficient of thermal expansion are nearly zero.
  • Depending on their physical shapes, will not crack even when heated to 1,000 degrees Celsius and subsequently thrown into water.
  • Show excellent non-wetting behavior in contact with fused aluminum.

Table of Physical Properties

Product group FTA-PS
Materials Aluminum Titanate
Appearance Non-porous
Chemical Ingredients
(Wt%)
Al2O3 50%
TiO2 40%
SiO2 8%
Specific Gravity
(g/cm3)
3.1
Water-absorption Rate
(%)
1
Thermal Conductivity
(W/mk)
-
Flexural Strength
(MPa)
10
Refractoriness
(℃)
1000
Impedance
(20℃,Ωcm)
-
Thermal Shock Resistance
(℃/hr)
1000
Color Appearance Grey
Intended Application Metal Melting Crucibles
Setters
Sintering container(Battery materials / Electronic parts)

※Note that the features listed above are reference values and are not guaranteed.