Yttria Stabilized Zirconia (ZrO2) CIP Products

Features

CIP (Rubber Press) Products are highly and homogeneously condensed non-porous products because they are made under the ultra-high pressure in all the directions.
Rubber molds, which are suitable for smaller quantity production but less expensive, are used in the CIP manufacturing process.

Product group : FZ-PSY

  • Ceramics with high level of intensity and fracture toughness
  • The most popular materials for wear resistant or shock resistant parts

Product group : FZ-PS8Y

  • Having unique features which differs from that of alumina in response to metals
イットリア部分安定ジルコニア(ルツボ、リング、チューブ)
イットリア部分安定ジルコニア(粉砕ローラー・撹拌羽・粉砕羽)
イットリア部分安定ジルコニア(粉砕羽・攪拌羽)
イットリア部分安定ジルコニア(管)

Table of Physical Properties FZ-PSY Series (Crucibles, Rings, Tubes, Pot Mills and Ferrules)

Product group FZ-PS3Y FZ-PS8Y
材質 Partially Stabilized Zirconia Fully Stabilized Zirconia
Appearance Non-porous
Chemical Ingredients
(Wt%)
ZrO2 94 86
Y2O3 5.5 (3mol) 14.0 (8mol)
Al2O3 0.2 0.0
Specific Gravity
(g/cm3)
6.0
Water-absorption Rate
(%)
0.0 0.0
Thermal Conductivity
(W/mk)
3
Flexural Strength
(MPa)
1200
Normal operating temperature
(℃)
1000 1400
Impedance
(20℃,Ωcm)
10?13
Thermal Shock Resistance
(℃/hr)
300 -
Color Appearance Milky White
Intended Application Wear resistant parts(Nozzle, Ring and Bearing)
Parts with characteristic feature of high-intensity and fracture-toughness
Zirconia pot mills
Screwx / Stirring blades
Jigs for sintering electronic parts(Corrosion resistant setter)
Thermal insulation materials

※Note that the features listed above are reference values and are not guaranteed.